pauly Instructions

When removing the main ring from the foam inlay, please do not reach into the fabric, but only into the outer recessed grips in the foam.

The Pauly Pop Filter is an indispensable tool to protect your voice recordings from disturbing artifacts originating from the human voice itself, such as plosives. This enables you to decisively enhance the quality of your recordings, avoiding problems in the later mixing process. The Pop Filter’s sophisticated design and high-quality workmanship ensure a strong but still gentle effect. When recording, frequency range and natural quality of the voice remain fully intact, while filtering pop sounds and disturbing artifacts of similar origin. Thus, your performance retains all of its vibrancy. This is the true strength of the Pauly Pop Filter.

Once you have preset the desired position of the filter ring by bending the gooseneck, simply lock the ring in place using the knurled round nuts – unless you want to continue twisting or bending the gooseneck to find the perfect position. The knurled round nuts are located between the tip of the gooseneck and the filter ring. When screwing the filter ring onto the gooseneck, be careful not to jam the thread.

The Pauly Spider Clip practically fits any closed spider mount of large membrane microphones. The clip is attached to the outer spider ring. Open the Spider Clip’s wing nut far enough to easily hook the front piston claw on the outer round bar of the microphone spider, turning it gently. Then gently re-attach the wing nut. Please avoid scratches on the spider rod with the attached protective tubes or a piece of adhesive tape.

The Pauly Adapter Cone, attached to the separate stand, is extremely versatile and independent of the microphone used. It should help to be able to use the Pauly ring independently of its original holders such as gooseneck or spider clip.

The filter ring should be positioned at a distance of 1,5 to 4 inches (4 to 7 cms) from the microphone, keeping the center of the ring and the center of the microphone capsule on one straight line. With each narrator / singer, the correct distance between the Pauly filter ring and the artist should be determined individually. Usually about 4 fingers wide – with quiet, intimate speech or vocal passages even a few centimeters are enough. (The tissue should not be touched with the nose or lips!) Should small tissue damage occur during use (except holes), this does not affect the good filter properties.

Starting in 2027, our goosenecks will be equipped with a newly developed, open U-shaped retaining bracket. This means that when attaching or replacing the pauly pop filter on the microphone stand, you will no longer need to unscrew the microphone as you did before. If you are retrofitting the old bracket with the new one, the milled side of the U-shaped retaining bracket should face downward.

First, the original gooseneck flap is unscrewed. You can now screw the gooseneck onto the M 4 grub screw. An Allen key with a spare screw is included.

The filter can be disinfected by lightly spraying it with a colorless disinfectant but should be dry before recording. If disinfection is needed more frequently (after about 5 times), the ring should be soaked in warm water with a little dishwasher liquid without care substances, fabric softener and excessive scents or coloring for some minutes. Move it around gently, rinse in clear water, then shake off the water and let dry. If in a hurry, place the filter ring near a radiator, but do not use a blow dryer. This procedure cleans the filter fabric, removes any foreign objects and renders the fabric fluffy and elastic again.

Sometimes, careless handling of the Pop Filter can cause minor damage to the fabric. This damage looks like small lines, but does not impair the filter‘s effectiveness. You can easily remove them by pressing both fabric surfaces firmly together with your thumb and index finger on both hands to the left and right or above and below the damage, and then pulling them apart with a quick jerk. This will make a quiet crack, and the damaged area will disappear.

With the fingernail a toothpick or something similar, the replacement filter is to detach from the main ring. This is done in seconds.
All replacement filters have 4 small hooks on its inner side of the ring. When inserted into the perforated main ring, one of the hooks should be positioned directly in front of one of the holes. Because then, with a little pressure, the other three hooks also snap into the holes of the pauly main ring. The Replacement Filters are washable, preferably swirl in warm soapy water, then rinse with clear water and let dry in the air.
To reorder at www.paulyton.de.

Service e-mail: order@paulyton.de
Service phone: +49 (0) 6406 8360248
www.paulyTon.de

paulyTon
High-Class pop filter technology – Made in Germany